signaling.
3)Press [OK] or [PTT] to keep the setting; press[CLR] to exit and
quit the setting.
4)If CTCSS has been set,
CT
appears on the LCD while receiv-
ing; If DCS has been set,
DCS
appears.
Change the CTCSS / DCS Code for Channel Transmitting:
1)Press [F], [8].
CTCSS / DCS code or
OFF
appear on the screen.
2)Press [MENU] to switch between CTCSS and DCS.
While selecting CTCSS,
TC
and CTCSS code appear. Rotate the
Channel Selector to select the desired CTCSS code,
OFF
means
no CTCSS / DCS signaling.
While selecting DCS, TD
and DCS code appear. Rotate the Cha-
nnel Selector to select the desired DCS code, press [F] to select the
positive or negative code.
OFF
means no CTCSS / DCS
signaling.
3)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
4)If CTCSS has been set,
CT
appears on the LCD while transm-
itting; If DCS has been set,
DCS
appears.
Offset Frequency Setting
In the full-frequency display mode, offset frequency setting is
a v a i l a b l e . O f f s e t f r e q u e n c y s e t t i n g m a k e s t h e t r a n s m i s s i o n
frequency ) or lower(-) than the received frequency to
increase communication range by a repeater.
1)Press [F], [4]. Rotate the Channel Selector to select
offset
frequency or
OFF
. If
+
offset frequency is selected,
+
appears on the screen; if
-
offset frequency is selected, -
appears; if
OFF
is selected, the frequency for transmitting
and receiving will be the same.
2)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
3)Press [F], [5] and rotate the Channel Selector or input the offset
f r e q u e n c y d i r e c t l y b y t h e k e y p a d . T h e r a n g e 0 0 . 0 0 0
37.995MHz is available.
4)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
Deleting Memory Channel
1)In the memory frequency mode, select the desired channel (the
channel is not locked out).
2)Press and hold [CLR] for 2 seconds, LCD display
DEL-?
.
3)Press [OK] or [PTT] again to delete the selected channel.
Deleting All the Memory Channels
1)Switch off power.
2)Press [CLR] and meanwhile rotate the Power/Volume Switch to
switch on power, LCD display
AL.DEL?
.
3)Press [OK] or [PTT] again to delete all the memory channels.
Channel Lockout
Channel Lockout is to avoid the channel being deleted or covered.
1)In the memory frequency mode, select the desired channel.
2)Press [F], [MENU],
appears below the channel number to
show that the channel has been locked out.
3)To unlock, press [F], [MENU] again.
14
13
