KIPI ecoMAX920 P1-CH, Руководство по эксплуатации и установке

Страница: 18 / 34

18
5 Technical data
Regulator power supply 230 V~, 50 Hz
Current consumed by the
regulator
0,04 A 1
Maximum rated current 6 (6) A
The degree of protection of
the regulator
IP20
Ambient temperature 0...50  C
Storage temperature 0...65  C
Relative humidity 5…85%, without
condensation of steam
Temperature measuring
range of sensors CT4
0..100  C
Temperature measuring
range of CT2S sensors
0..300  C
Temperature measuring
range of the CT6-P sensor
-35..+40  C
Accuracy of temperature
measurements with sensors
CT4, CT6-P
±2  C
Connections Screw terminals on the
mains voltage side of
2.5 mm2
Screw terminals on the
control side 1.5 mm2
Display Colorful, graphic
480x272 pix. with a
touch panel
External dimensions EcoTOUCH3 control
panel:
144x97x17 mm
EcoTOUCH control
panel:
148x97x23 mm
Controller module:
340x225x60 mm
Mass 2 kg
Standards PN-EN 60730-2-9
PN-EN 60730-1
Software class A
Protection class To be built into class I
devices
The degree of pollution 2nd degree
Warehouse conditions. and
transportation
5.1
The controller cannot be exposed to direct
influence of weather conditions, i.e. rain and
sun rays. Storage and transport temperature
should not exceed the range -15… + 65 ° C.
During transport, the regulator must not be
1
Jest to prąd pobierany przez sam regulator. Całkowity
pobór prądu zależy od podłączonych do regulatora
urządzeń.
exposed to vibrations greater than those
corresponding to typical conditions of wheel
transport.
IP protection class
The casing of the regulator provides IP20
protection. The casing on the side of the
terminal cover has the IP00 protection
degree, therefore the terminals must be
absolutely covered with this cover. If there is
a need to gain access to the parts with
terminals, first disconnect the mains power
and make sure that there is no mains voltage
on the terminals and wires.
Connecting the electrical installation
The
regulator is designed to be supplied with ~
230 V, 50 Hz. The electrical installation
should be:
 three-wire (with PE protective wire),
 in accordance with applicable
regulations,
 equipped with a residual-current
switch with a tripping current
IΔn≤30mA protecting against the
effects of electric shock and limiting
damage to the device, including fire
protection.
After the regulator is turned off,
dangerous voltage may occur on its
terminals. Before starting assembly
works, you must disconnect the
mains power and make sure that
there is no dangerous voltage on
the terminals and leads.
The connection cables should not have
contact with surfaces with a temperature
exceeding the nominal temperature of their
operation. Terminals 1-22 are intended for
connecting devices with ~ 230 V mains
supply. Terminals 23-48 are intended for
cooperation with low-voltage devices (below
12 V).
Connecting the ~ 230 V mains
voltage to terminals 23-48 and G
transmission connectors damages
the regulator and creates a risk of
electric shock.
The ends of the connected wires, especially
those with mains voltage, must be secured
against splitting, e.g. with clamping sleeves,