Kioti Daedong EX35C, Руководство пользователя

Страница: 196 / 229

7
-33
MAINTENANCE
7
666
11
22
99
4 4
77
88
33
10 10
55
H11O646A
3. When the amount of the fuel in the
fuel filter port goes over 3/4 level, stop
cranking the engine and turn the cock
in the figure to the “ON” (open)
position.
It is not necessary to bleed the
system if filling the tank with fuel
before installing the fuel port.
NOTE
Do not operate the start motor
for more than 10 seconds
continuously. Instead, operate it
for several times within 10 sec-
onds each time.
!!!!!
CAUTION
4. Unscrew the bleeding bolt in the fig-
ure and crank the engine to bleed
the system. Then, tighten the bolt.
5. If the engine still cannot be started
even after performing the above step,
unscrew the 1 or 2 nozzle holder nuts
out of 3 or 4 and crank the engine to
bleed the system.
6. When air bubbles are not seen any-
more in the drained fuel, tighten the
loose parts and start the engine.
(1) Fuel Tank
(2) Fuel Filter
(3) Fuel Injection Pump (4) Injection Pipe
(5) Injection Nozzle
(6) Fuel Overflow Pipe (Hose) (7) Fuel Feed Pump
(8) Bleeding Bolt
(9) Bleeding Hose
(10) Nozzle Holder Nut
2. If there is air in the fuel filter, turn the filter cock to the air side and turn the
ignition key to turn the start motor. Then, the air in the filter port is discharged
through the bleeding hose as shown in the figure.