30
LOGF30 PLACEMENT GUIDELINES
30 inch Log support
When using the LOGF30 log, you must attach the 30 inch log supports
found in the log set.
Step (1)
Align front hole of 30 inch log support plate with original log locator pin.
Step (2)
Slide the 30 inch log support over log locator pin. Using two 6-32 x 5/16
screws, mount plate to burner grate. NOTE:
Make sure log support is tight
against side of burner grate before fastening.
Log
Locator
tabs
Log locator pin
Rear log holder
Grate Bars
Step (3)
Place front log by positioning the notches
on the underside of the front log with the grate bars
and pull forward.
Step (4)
Place left front log by positioning the slot (located on the
bottom of log) with log retainer tab and lower into position.
Step (5)
Place right front log by positioning the slot (located on
bottom of log) with log retainer tab and lower into position.
Содержание ZVF33
Страница 2: ...2...
Страница 27: ...27 Step 5 Place log A onto rear log holder and pull up to log C D LOGF18 PLACEMENT GUIDELINES continued...
Страница 29: ...29 Step 5 Place Log C onto front burner LOGF24 PLACEMENT GUIDELINES continued...
Страница 32: ...32 CAUTION Do not wire 120 Volt power to Millivolt switches or thermostats MILLIVOLT LIGHTING INSTRUCTIONS...
