20
BURNER REMOVAL AND REPLACEMENT
1.
Turn OFF the Gas and Electric
Power before servicing the Fireplace.
2.
Remove doors. Remove end, back
or side bricks, this depends on type
of Fireplace installation. Remove all
Crushed Rock and Glowing Embers.
Vacuum inside of Fireplace for
remaining dust particles. FIGURE 1.
3.
Lift and remove Burner Deflectors
from Burner. Remove four screws securing
Burner and slide Burner away from
back of Fireplace until it clears orifice.
Lift and remove Burner.
DO NOT force up or sideways, as
this may damage Venturi. FIGURE 2.
4.
To replace, reverse procedure.
VALVE REMOVAL AND REPLACEMENT
1.
To remove Valve first follow Burner
instructions.
2.
Remove GAS line and Deflector Pan.
3.
To remove Valve Pan, first remove
self tapping screws, then using a knife
slide it between Pan and Firebox
bottom. This will separate the High Heat
Silicone bond. Carefully remove Pan and
Valve from Fireplace. FIGURE 3.
4.
To replace, first clean any Silicone
from Firebox bottom. Reapply Fresh
HIGH HEAT SILICONE as in Figure 3
and reverse all procedures.
BURNER AND VALVE R&R INSTRUCTIONS
FIGURE 1
FIGURE 2
BURNER DEFLECTORS
BOTTOM BRICK PANELS
NOT AVAILABLE
HIGH TEMP
SILICONE
DEFLECTOR PAN
BURNER PAN
BURNER
FIGURE 3
