Kingsman IDV33-IDV36, Руководство по установке

Страница: 10 / 29

10
Note: Use black millpac on vent pipe joints!
1. First remove the decorative top cover (5 screws). Then simply lift upwards. (fig #1)
2. Remove adapter plate from unit by removing the two screws as shown below. (fig #3)
3. Attach the vent pipes to the termination with millpac and 4 screws per pipe joint. Be sure to
label the exhaust and intake flex pipes. Make sure not to connect the exhaust to the intake
or vice-versa. Lower the termination and vent pipe down the vent and screw and seal plate
to the chimney crown, clay tile chimney or wood stove vent. It may be necessary to pre-drill
holes into the chimney crown (depending on material) (8 screws).
4. The two vent pipes should now be hanging in the existing fireplace. Attach the adapter to the
2 suspended vent pipes with millpac and screws. Let the adapter hang in place until unit is
ready to be positioned.
5. Once the adapter is suspended by the vent pipes going up
to the termination cap slide the unit into place carefully.
(fig #2)
6. You want the adapter to
slide along the top of
the unit between
the guides making
sure it remains
flat. (fig #2)
7. Once the unit is
slid back into
position use the
2 screws
previously
removed
to secure the
adapter plate.
When tightening
the adapter plate
check to make
sure the plate is
flat to the unit
and the rear
catch lock is
engaged over
the rear tab of
unit. (fig # 2 & #3)
Venting System:
IDVVT Vertical Vent Termination
IDVFK25 Flex Pipe kit (2ea 3” x 25ft unexpanded flex pipes complete with millpac,
screws.)
#0991 Simpson Duravent Co-linear Termination HW Vertical Top
#0923GK Simpson Duravent Co-linear Adapter for Co-Liner Termination
Note: When using Simpson Duravent Termination order both #0991 and #0923GK
Vertical (rise) Horizontal (run)
Min. 10 ft - 3.1m 0 ft - 0.0m
Max. 40 ft - 12.2m 2 ft - 0.6m
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
INSTALLATION INSTRUCTIONS
Vertical Termination IDVVT
1. Before attaching the flex vents to the termination, you will have to determine how the cap will
be attached to the existing chimney crown, clay lined chimney or wood stove vent pipe.
The Seal Plate of the termination may be cut, notched and formed to make a good seal to the
existing vent or be left flat.
2. Using a high quality sealing compound (RTV Silicone) place a bead of sealant onto the vent or
chimney top. This will provide a seal against water and rain from entering the existing flue.
Installation of Vent Pipe