KingCraft Super Stearman, Инструкция по эксплуатации

Страница: 9 / 34

I
5. Wing servo installation:
Rtcommend Ali.rotl
--
T'Ofq!Je ; <S Kg(cm
$pe«I ' > . l 6 �
r---------
""'l! - 111!!"'-,-
---------;-----------
,
-----
.. h-6.0V
TOPVIEW t
-tt=
!
Lower w1ng
You may use any standard size servo with a 6 -7Kg/cm torque for the aileron controL Use 4 off 8 x
12mm self tapping screws to secure the servo to the servo mount cover as shown. Ensure the servo
control horn can move freely without rubbing the opening and trim the servo mount to fit if required.
7
The length of the aileron pushrod.
52mm
)lo
21
.,
To achieve a symmetrical travel and the optimum travel
resolution on all control surfaces the servo control arm
must be at 90 degrees to its servo case. The control
linkage should be attached to the farthest end of the
servo ann as shown, You
may
use a sub-trim function
on your transmitter to achieve the exact neutral position
if
your
servo ann is just slightly off from the center.
(Consult with your TX radio instruction manual for set up
details.