KingCraft Super Stearman, Инструкция по эксплуатации

Страница: 18 / 34

I
13. Tailwheel installation:
Mounting plate
� ----:!I.
Insert the tail wheel into
the metal bracket, push
�
�
the pin through the
bracket and the wheel
using pliers. Insert a
C-clip into the groove on
each side of the pin.
Install the tail wheel assem-
M3 x 8
bly onto the plywood with 2
hex screws
o� M3x 8 hex screws.
L.:::====;;;;::. ___
a; :::,a _ _ _ _ -
Please note: The hinge and the scale like u-shaped rudder control horn has to be installed prior to the
rudder installation. Use epoxy glue to permanently bond the control horn in place as shown. Ensure the horn
is installed properly without misalignment. Glue the hinges into the leading edge of the rudder as shown .
....--
Drill a hole in the rudder for the tail wheel steering arm. Align those rudder hinges and the tail wheel arm in
line with the vertical fin center line. Then trial lit these parts into the pre-cut slots on the vertical fin. Once
satisfied with the lit, you may apply some CA glue to the hinge and apply some epoxy glue to the tailwheel
steering arm. Ease the parts together and use some masking tape to hold them whilst the glue dries.
16