KingCraft Super Stearman, Инструкция по эксплуатации

Страница: 25 / 34

I
20. Motor and ESC installation:
Pic#1
..
.,,.
.
., .
. .,.
.
·
.
.,�
_
.. ····
. •
oo
·
- � · o ·
·
.
--:o�
•·
.,
.·
· ·· . fl'
M4x12screws
. •
Choose your desired motor according to our recommended power range. There are so many different
motor sizes on the market so it is hard for us to tell you exactly how to install it on this model. If you follow
the guide below you will still be able to achieve good results with the motor installation.
Right thrust angle:
2-3 degrees
Down thrust angle:
1-1.5 degrees
•
3mn
•
Attach the X-mount to the motor using the set of screws supplied with a crosshead screwdriver, use
some threadlock to secure the screws. You can see the line on the firewall is offset to allow for the
side thrust. Install the X mount on the offset line mark which is about 5mm to the left of the center line.
Add washers behind the X-mount (See pie #1) in order to achieve the correct right thrust at the same
time. 3-4 washers will achieve the correct right thrust angle. By aligning the motor on the offset line this
will bring the motor shaft back to the center axis of the plane when the motor has been installed.
Elevator and rudder servo installation. The servo
mount cut-out size is 28mm x 12 mm You may
need to trim the servo mount cut-out if you want to
use a bigger size servo with more torque.
23