KingCraft Super Stearman, Инструкция по эксплуатации

Страница: 19 / 34

I 14. Rudder servo and linkage installation :
Before we start making the cables and fnstalllng them remove all the
supplied c-ables, threaded studs. adjustable pushrod adjusters and
clevises from the accessory bag. You need to make 2 pull-pun cables to
allow the rudder to work. Ffrst. cut 2 lengths of cable that are long
enough to reach from the servo to the rudder control horn plus about
40.50mm or so. this will make it easier for you to make the Joops on the
ends and crimp the tube. Feed one end of the cable through the
fuselage in to the servo compartment. At the servo end slip a crimp
tube over the cable then loop the cabte through the hole in the threaded
stud and then loop the cable back into the tubing and pull the cable to
form a small loop about 12mm long. Now bend the cable back along
the tubing and slide it back into the tubing.
Use long nose pliers to pull out all the slack and reave as.mall loop. this
is why you need the extra cable length. When the cable is pulled tight
and you have formed a small loop. (8'"' photo above) use a crimping
tool and make two crimps to lock the tubing into place. Repeat this
process on the other end of the cable (control horn end). Once you
have one cable made make another identical one for the other side.
Once both cables are made screw a clevis on the rudder hom end and
teed the servo end through the servo connector. Adjust the clevis and
the servo connector end on both cables until both are tight and there is
no Slack to the rudder and the rudder is neutral.
111111
I
�
Insert the fiber tabs of the flying wire fixings halfway into the pre-cut slots o
CA glue to fix them in place.
17