Page 7 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
6. Function Programming
Tips:
1) The Administrator password is for setting the parameters, the User password is for operating the
units after setup. The administrator password and the user password cannot be the same.
2) In order to save the backup battery lifetime, please charge it at least 12hours or full at the first time
to run the unit.
3) When the external AC Power goes off, the relay output and siren still can work.
6.1 Initialization
Please insert SIM card and insert the adapter output terminal into the power hole of the host, and then
power on the system. It will show the GSM alarm system is good when built-in buzzer rings again per
second with the signal light flashing again per second, and about 15 seconds a long ring with the signal “five
lattice” on the screen. The signal lights flash every one seconds if the alarm system is good.
Last, please turn on the backup battery switch.
6.2 System setting
In the state of disarm, input 4- digit administrator password by the keypad on the host and press [#] button
to confirm. You will hear a voice prompt: please enter instruction. At the same time,[set] indicator is on
without flashing and
［
- - - -
］
displays on the screen, indicating the system enters setting status. You can
perform different settings repeatedly as long as the system keeps in setting status. The system will exit
setting mode and return to disarm status. The system will exit setting mode and return to disarm status if
you don't press any keypad button for 40 seconds.
Note
: The default administrator password is [6666].
Operating method:
[XXXX]
Ö
[#]
X
indicates: 4-digits administrator password.
LCD display:
6.3 Exit Setting
Press [*] and [#] buttons, the host emits a long beep and exits settings. The [SET] indicator goes out and the