King Pigeon S100Pro, Руководство пользователя, Страница: 21 / 25

Page 21 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
host keypad “Emergency Alarm[SOS]” ,remote control key [ ! ]. Alarm system will immediately call the
preset Auto dial phone numbers.
Remote operation: press remote control [
!
]. The siren will sounds
Keypad operation: press console keypad [SOS].the siren will not make sounds.
7.11 Used as a Phone Dialer
This alarm system has dial-up function and could be used as mobile phone.
Enter phone number, then press
［ ］
, main host makes a long beep,
［
signal
］
light starts flashing at the
same time. Call completed, press
［ ］
, hang up, Main host will be in disarming state.
8. Wireless Detectors activated method
a) Remote Control and Wireless Detectors activated method:
For remote control, press any key then can activate it, no need to press all of them.
The wireless door contact can be triggered by dispatch the two parts when installed battery inside;
The wireless PIR Motion Detectors can be triggered by pass though its front when switched on;
The wireless panic buttons can be triggered by press its button;
The wireless gas leakage or wireless water leakage and wireless smoke detector equips Test Button, press the
Test Button then can trigger them.
The other wireless detectors please reference its user instructions.
b) When the wireless PIR Motion detection is PIR-100B, please remember setup the PIR-100B to Test Mode while
learning to the S100Pro, after learned to the S100Pro, then please setup to Normal Mode by change the Black
PIN Jumpers in the PCB, please see the PIR-100B user manual.
c) The differences of PIR Motion Curtain Motion and Ceiling motion detector are the detection direction areas.
d) When the wireless Detectors is PT2262 fixed IC code, please setup its wireless code by use some Jumpers to
configured it randomly, recommend 4~6 jumpers, see below:
1) Removing the back cover carefully;
2) Locate the IC boards black jumpers, labeled A0-A7 and D0-D3, please see below figure.
3) Configured the A0~A7 and D0~D3 different from each wireless detectors. If configured the A0~A7 and D0~D3
are the same, the system will treat them as the same one sensor. So if you want to add more than one wireless
detector to any zone, please configure the jumpers as the same in the wireless detectors.
4) Also, please check the Resistors value is 3.3M Ohm, there’re 3 Jumpers, 1.5M, 3.3M, and 4.7M. if you select
incorrect value, the wireless distance usually very short or cannot learn to the S100Pro.
1) Some popular wireless detectors