Page 12 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
Operating method:
[35]
Ö
[02]
Ö
[#]
LCD display:
6.17 Dial-in Ringing Times Setting
Users dial-in the host, the host will ring how many times then voice prompt to input password to get remote
control setting to the host.
In setup state, press [36], then input delayed time [0~9] sec., finally press[#] to
confirmed. Main unit make a long beep. A “setting completed” voice prompt appear.
Operating method:
[36]
Ö
[X]
Ö
[#]
X
indicates:ring times;
Example: After receiving two ringing signals, start the host to work remote control
Operating
method:
[36]
Ö
[2]
Ö
[#]
Notes: The host remote control closed , when ringing times is set to 0
LCD display:
6.18 Vocie Recording
In setup state, use keypad to input [37],and then press[#] to confirm.The host will emits a beep and the [
] indicator is on, and after 10 seconds countdown, recording starts: record at 30cm away from the host with
moderate tone;10 seconds later, the host will make a beep indicating the recording finish and the recorded
voice will replay.
Operating method:
[37]
Ö
[#]
LCD display:
Note:
when you need to change the content of recording, just store your new one.
6.19 Modify Passwords
***Change User Password
User password is the key to enter the host operating system when start Disarm or Remote Control.
In setup state, use keypad to input [38], then input the 4- digit new password, finally press [#] to confirm. The
main unit will make a long beep and you will hear a voice prompt “ setting completed”.
Operating :
[38]
Ö
[XXXX]
Ö
[#]
XXXX
indicates:the new 4-digit password
Example: change the system password to 1012;
Operating:
[38]
Ö
[1012]
Ö
[#]
LCD display: