Page 19 of 25 Ver 1.0
A Top Safety and Protection Solution In The Worldwide!
will call the next user number automatically. The system will call each preset numbers for 3 times in order.
If you answer the all, you will hear the pre-record voice. You can set system via your telephone or mobile
phone keypad.
If you hang-up directly without answering the call, system will call each preset number for 3 times circularly.
Press [*]:
Read the alarm information.
Press [1]:
The host stops alarming and to Arm; it stops calling users.
Press [2]: The host
stops alarming and to Disarm; it stops calling users.
Press[3]: The host closes
Siren and monitors the scene for 30 seconds, for continuous monitoring, press
[3] again to monitor the abnormal sounds or a burglar intrusion for another 30 seconds.
Press [4]:
start talkback 30s.
Important: Please remember press # to exit, otherwise, the host will call next phone number.
7.7 Remote control by call in
The telephone (mobile) is connected to alarm host number, and after ringing times setting, the telephone
receiver prompts computer-generated voice: “Please enter password”.
(Important: every second enter
only 1 digit, and the host will make di sound to confirm then you can start to enter the next digit,
otherwise will warning wrong password.)
The password is user password and entered via telephone
(mobile). For wrong password, the host gives prompt: “wrong password, please enter password again”. For
correct password, the telephone receiver prompts “press
①
to arm, press
②
to disarm, press
③
to
monitor, press 4 to talk ”. And after it is accessed, phone button could be used for remote control.
Press [1]:
the host enters Arm state and voice prompts “Armed”.
Press[2]:
the host enters Disarm state and voice prompts “Disarmed”.
Press [3]:
the host enters monitoring state for 30 seconds and press [3] for 30 seconds delay repeatedly in
case of continuous monitoring.
7.8 SMS Commands for Arm(Away) or Disarm or Switch On/Off Siren.
The User can Arm/Disarm/Switch on or off the siren by sending SMS to the S100Pro. The SMS
Commands are below:
Notice:
The system will carry out the commands immediately (with no delay) after the S100Pro receive this SMS command.
Armed(Away)
Disarm
Switch On the Siren
xxxxAA
“xxxx” stands for the user
password (4 digits).
Return SMS
Armed
Example
1234AA
When the Password is 1234
Example
1111BB
When the Password is 1111
xxxxBB
“xxxx” stands for the user
password (digits).
Return SMS
Disarmed