ASSEMBLY
MOUNTING BELT AND DISC SANDER TO WORKBENCH
If the belt and disc sander is to be used in a permanent location, it should
be fastened securely to a firm supporting surface such as a workbench.
If mounting to a workbench, holes should be drilled through supporting
surface of the workbench using dimensions illustrated on the right.
1. The unit should be bolted securely using 5/16" screws and hex nuts
(not included). Screw length should be 1-1/2" plus the thickness of the
bench top.
2. Locate and mark the holes where belt and disc sander is to be mounted.
3. Drill (2) 3/8" diameter holes throught workbench.
4. Place belt and disc sander on workbench aligning holes on base with
holes drilled in workbench.
5. Insert two 5/16" screws and tighten hex nuts.
An altemate method of mounting is to fasten belt and disc sander to a
mounting board and should be of sufficient size to avoid tipping of sander
while in use. Any good grade of plywood or chipboard with a 3/4"
minimum tinckness is recommended. (Thinner chipboard can break).
CAUTION
: To avoid injury from tool movement, use 5/16" or larger
screws and nuts .
1. Follow instructions for mounting to workbench, substituting a board
18"x 24" minimun size and using 5/16" inch flat head screws lock
washer and hex nuts (not included). Screws length should be 1-1/2" plus
the thickness of the mounting board.
NOTE
: For proper stability, holes must be counter sunk so screw heads
will be flush with the bottom suface or supporting board.
CAUTION
: To avoid injury from tool movement, supporting surface
where belt and disc sander is mounted should be examined carefully
after mounting to ensure that no movement during use can result. If any
tipping or walking is noted, secure workbench or supporting surface
before operating belt and disc sander.
CLAMPING BELT AND DISC SANDER TO WORKBENCH
The belt and disc sander can be clamped directy to a workbench using
two (2) or more "C" clamps on base of unit (one clamp on each of unit).
INSTALLING SANDING DISC AND GUARD
1. Locate sanding disc and peel backing from disc. Align perimeter of
disc with plate and press disc firmly into position all the way around.
2. Locate disc guard and two pan head screws, from loose parts bag.
3. Position disc guard against lower l/3 of disc aligning holes as shown.
4. Using Phillips type screwdriver, fasten the pan head screws securely
applying slight pressure to thread the holes.
Outline of sander
2 Holes
3/8” diam.
All mesurements are in inches
Mounting hole
Mounting hole
Workbench
“C” clamp
Sanding plate
Disc guard
Screws
Sanding disc
