ASSEMBLY
8. Use your Instruction manual as a spacer. Place ten pages of the
Instruction manual between the disc and the front edge of the table.
Hold the table against the manual and tighten the three (3) hex. hd.
screws.
AUXILIARY MOUNTING FOR VERTICAL SANDING
1.Remove backstop lock bolt and remove work support.
2. Remove table assembly by removing table lock knob and washer.
NOTE
: Belt bed may be raised to vertical position by loosening hex.
socket screw and raising bed. See "Positioning Belt Bed".
3. Attach table assembly to auxiliary holes in belt bed. Make sure index
pin is in the upper hole when sanding table is in the vertical position.
SQUARING TABLE ASSEMBLY
WARNING
: To avoid injury from accidental starting, make sure tool is
unplugged before aligning.
1. Using a combination square, check the angle of the worktable with the
disc.
NOTE
: The combination square, must be "true"- See "Unpacking - Tools
Needed" section.
2. If the table is not 90
0
with the disc, loosen table lock knob screw and
tilt table.
3. Adjust worktable square to the disc and retighten table lock knob.
4. Attach scale label to 0
0
mark on dust guard.
Instruction manual
10 pages
Work table
Table lock knob
Scale label
Table support
Washer
Table lock knob
Pulley cover
Auxiliary
mounting holes
Backstop removed
Combination square
Worktable
Table lock knob
Scale label
