ASSEMBLY
INSTALLING BACKSTOP
1. Locate backstop and hex. screw, washer and lockwasher.
2. Hold work support into position and fasten as shown. Do not
overtighten.
INSTALLING TABLE ASSEMBLY
1. Locate table support and (3) hex. nuts washers and lockwashers
among loose parts.
2. Position table support against table, aligning holes as shown.
3. Fasten table support to table with hex. nuts washers and lockwashers
as shown.
4. Locate washer and knob among loose parts.
5. Position table support in corresponding holes on side of base as
shown. Make sure the 9.5 mm diameter index pin aligns with upper
hole.
6. Place washer on threaded shaft of knob and insert throught slot into
holes of base.
WARNING
: To avoid trapping the work or fingers between the table and
sanding surface, the table edge should be a maximum of 1/16 inch from
sanding surface.
7. Loosen the (3) hex head screws and adjust table.
Backstop
Work support hex. screw
Hex. Nut (3)
Table
1/16” Maximum
Table
Sanding surface
Lock washer
Hex. Screw
Flat washer
Wrench
Table support
Washer (3)
Lockwasher (3)
Base
Washer
Table lock knob
Index pin
Table
support
