ASSEMBLY
INSTALLING THE SANDING BELT-
TENSIONNING AND TRACKING
WARNING
: To avoid injury from accidental starting, turn switch "OFF”,
remove key and remove plug from power source outlet before removing
or installing sanding belt.
On the smooth side of the sanding belt, you will find a "directional arrow".
The sanding belt must run in the direction of this arrow so that the splice
does not come apart.
1. Slide tension lever to the right to release the belt tension.
2. Place the sanding belt over the drums with the directional arrow
pointing as shown. Make sure the belt is centered on both drums.
3. Slide tension lever to the left to apply belt tension.
4. Tighten hex. socket screw when bed is in desired position.
5. Plug in the power cord. Turn switch "ON" and immediately "OFF",
noting if the belt tends to slide off the idler drum or drive drum. If it did
not tend to slide off, it is TRACKING properly.
6. If the sanding belt moves toward the disc, turn the tracking knob
clockwise 1/4 turn.
7. If the sanding belt moves away from the disc, turn the tracking knob
counterclockwise 1/4 turn.
8. Turn switch "ON" and immediately "OFF" again, noting belt movement.
Readjust tracking if necessary.
Idler drum
Tension lever
Directional arrow
Drive drum
Bed locking
hex. socket screw
Sanding belt
Tension lever
Tracking knob
