15
b
Remove the 2 screws holding the left hand board bracket. Remove the
bracket and left hand lining board.
c
Remove the screw holding the pilot draught shield to the pilot bracket and
lift the shield away.
d
Remove the six screws securing the control mount platform to the firebox.
Take care not to damage the gasket.
9
Replace the control mount platform (if it has been removed) and secure with the
six screws previously removed. Replace the pilot shield and the lining board and
bracket. Re-connect the gas supply. Place the burner and air guide assembly in
position ensuring that the mixing tube locates in its hole in the burner mount
over the injector and fix in place with the four screws removed in paragraph 5.
Replace the refractory shapes that were in place on the burner.
10
Replace the black ceramic granules in the tray attached to the air guide. Replace
the ‘Cotswold Stones’ exactly as they were removed making sure that the centre
row are replaced on the spikes using the original piecing in the stones.
11
After cleaning the glass door inside and out replace it and secure with the eight
nuts. Tighten the nuts evenly. Stubborn marks can be removed with steel wool
and detergent.
AFTER REFITTING THE APPLIANCE CHECK FOR GAS SOUNDNESS AT ALL GAS JOINTS.
12
Replace the fascia panel.
13
The service record sheet enclosed with these instructions should be complete to
maintain the validity of the warranty.
Battery Replacement
14
HANDSET; The handset is powered by one Alkaline 9volt PP3 size battery. If the
fire fails to respond to the handset control check that the red LED on the
handset lights whilst pressing either of the two buttons. If the LED does not
light, the battery in the handset requires renewing. To change the battery in the
handset, remove the battery cover on the underside of the handset, unclip the
battery from its connector and put a new one put in its place. Replace the
cover.
15
BURNER; Open the fascia panel. Lift out the gas control battery pack – signal
receiver from its position on the bottom tray of the convector box. Slide back the
battery compartment cover and replace the four AA size alkaline batteries
observing the correct polarities. Replace the cover and then replace the battery
box in its clip.
