10
6
Place ten ‘Cotswold Stone’ pieces from the second packet on top of the black
ceramic granules in front of the front air guide as shown in Figure 6.
7
Place the remaining ten ‘Cotswold Stone’ pieces from the second packet across
the air guides pushing each piece down on a location spike formed in the front
air guide. See Figure 7 on previous page.
8
It is important that decorative ‘Cotswold Stone’ pieces are placed as per these
instructions.
Closing the Glass Door
1
Place the glass door in position over the studs on the heat exchanger making
sure the joint in the rope seal lies along the lower edge. Secure in position with
the eight nuts. Tighten evenly.
Installing the Fascia Panel
1
Check that the fascia panel is mounted the correct way up. A TEE is punched in
the top of the inner flanges.
2
Ensure the four M4 screws are mounted in their bushes on the inner flanges.
3
Offer the fascia up to the appliance and slide the heads of the M4 screws
through the cut – outs and into the slots formed in the sides of the convector
box.
4
Make sure that the fascia panel slides up and down freely and locks in the top
position.
C
OMMISSIONING
:
1
Before attempting to light the appliance the gas supply must be turned on by
removing the cap from the isolator fitting and unscrewing the plug all the way
out. Replace the cap making sure that the tab engages with the slot in the top of
the plug. Tighten the cap securely. Check all joints with leak detection fluid.
Light the appliance in accordance with the instructions in the lighting section.
2.
a.
Slide back the battery compartment cover and insert the four AA size
alkaline batteries observing the correct polarities. Replace the cover and place
the battery box on the floor of the convector box.
b.
Fit the battery into the handset by removing the access cover in the rear
of the handset and inserting a 9 volt PP3 size battery. Connect the battery by
pushing the connector on to the terminals. Make sure the battery is connected
correctly. Replace the access cover.
Briefing the User
1
Demonstrate the full operation of the appliance to the customer.
2
Inform the customer that all cleaning procedures should be carried out only
when the appliance is cold.
3
Leave these instructions with the customer.
4
Advise the importance of having the appliance serviced on an annual basis.
