Kinco CD420, Руководство пользователя

Страница: 68 / 108

68
Result:
demand
I
= 1.89
Calculate
Factor
according to
filter
U
and
demand
I
:
* 2048* 4096
*
demand
filter
I
Factor
U Ipeak

Result:
1.89
* 2048* 4096 606
1740*15
Factor
 
Calculate log 2 _ Ana Dead according to the required dead zone voltage:
8191
2 _ *
10
dead
Analog Dead U
v

Result: log 2 _ Ana Dead = 410
Calculate log 2 _ Ana Offset according to the required offset voltage:
8191
2 _ *
10
shift
Analog Offset U
v

Result: log 2 _ Ana Offset =819
The following changes are required on the basis of Example 7-7.
Table 7-19 Parameter settings in Example 7-8
d3.26 Analog2_Dead Sets dead zone data for
external analog signal 2
Set to 410
d3.27 Analog2_Offset Sets offset data for
external analog signal 2
Set to 819
d3.31 Analog_Torque_Factor Sets the proportion
between analog signals
and output torque
(current)
Set to 2362
d3.00 Store_Loop_Data 1: Storing all configured
parameters for the
control loop
10: Initializing all
parameters for the
control loop
Set to 1
7.4 Internal Multi-
position Control Modes (“1” Mode)
In Internal multi-position control mode, we can activate internal set target position though an external signal to
control motors. The activation has two preconditions:
1, multi-
position control mode can only be activated in Mode 1, it can’t be activated in other modes.
2, At least one of the external input signal is defined as
―Internal position control 0‖, ―Internal position control 1
― or ―Internal position control 2 ―, which means at least one address of digital tubes-d3.01 ~ d3.07 is set to