Kinco CD420, Руководство пользователя

Страница: 23 / 108

23
Chapter 5 Trial Operation & Parameter Introduction
5.1 Trial Operation
5.1.1 Objective
The trial operation allows you to test whether the driver works properly, and whether the motor runs stably.
5.1.2 Precautions
1. Ensure that the motor is running without load. If the motor flange is fixed on the machine, ensure that the
motor shaft is disconnected from the machine.
2. Ensure that motor cables, motor encoder cables, and power circuits (power lines and control power lines)
are properly connected. For details, see Chapter 3.
3.
During the trial operation, if you long press ▲ or ▼ when the motor is running, pulse signals, digital input
signals, and analog signals of the external controller are temporarily unavailable, so safety must be ensured.
4. During the trial operation, the system automatically adopts the instantaneous speed mode, that
is, the ―-3‖
mode.
5. After the trial operation, Group F006 exits automatically. To enter Group F006 again, you must re-activate the
trial operation.
6. If motor/encoder cables are wrongly connected, the actual rotation speed of the motor may be the possible
maximum rotation speed, or the rotation speed is 0 and the actual current value is the maximum value. In
this case, make sure to release the button; then check cable connection and test it again.
5.1.3 Operating Steps
1. Press MODE to enter Group F004. Select t
he object address ―d4.18‖, and check the motor type.
2. Press MODE
to enter Group F000. Select the object address ―d0.02‖, and set the target speed to
―SpeedDemand_RPM".
3. Press MODE to enter Group F006. Arrange a test for keys, with the default value of d6.40.
Firstly, press ▼ to
adjust the data to d6.31. Then, press ▼, the data automatically changes to ―d6.15‖. Finally, press ▲ to adjust
the data to d6.25.
4. Press ENTER
to activate trial operation. In this case, the numeric display is ―adc.d‖, and the motor shaft
releases. When long pressing ▲ or ▼, the motor automatically locks, and runs according to
―+SpeedDemand_RPM‖ or ―-SpeedDemand_RPM‖ separately. During the trial operation, the numeric
displays the motor speed in real time.