Kimo ATE 310, Руководство пользователя

Страница: 17 / 24

7. F400 : Alarms management
Three alarms modes are available :
•
Rising edge (1 threshold) :
the alarm goes off when the measurement
exceeds
the threshold and stops when it
goes back below the threshold.
•
Falling edge (1 threshold) : the alarm goes off when the measurement goes below the threshold and stops when
it
exceeds
the threshold.
•
Monitoring (2 thresholds) : the alarm goes off when the measurement exceeds the high threshold and is below
the predefined minimum threshold.
When an alarm goes off, it is possible to acknowledge it by pressing the OK key on the transmitter : the sound, if it is
activated, turns off and the displayed value is flashing during the acknowledging (from 0 to 60 minutes). At the end of the
acknowledging duration, if the transmitter is still in alarm state, the sound is reactivated.
It is possible to set three different alarms :
•
The F400 folder corresponds to the alarm 1 setting.
•
The F410 folder corresponds to the alarm 2 setting.
•
The F420 folder corresponds to the alarm 3 setting.
The alarms settings procedure explained below corresponds to the alarm 1 setting. To set the alarms 2 and 3, go to the
folder corresponding to the alarm and perform the same procedure as for the alarm 1.
The transmitter is powered on.
➢
Press OK .
➢
Enter the activation code (see page 9).
➢
Press OK.
➢
Press Up key to go to the F 400 folder then press twice OK .
This folder is about the alarm mode.
➢
Press Up or Down key to select the required alarm mode :
17
F400 : Alarms management
Rising edge
Falling edge
Measurement (m) > Threshold (T) during time-delay T1 → Alarm activation.
Measurement (m) < Threshold (T) - Hysteresis (H) during time-delay T2 →
Alarm deactivation. Measurement (m) < Threshold (T) during time-delay T1 →
Alarm activation.
Measurement (m) > Threshold (S) + Hysteresis (H) during the
time-delay T2 → Alarm deactivation.
Monitoring
The alarm goes off when the measurement is outside the maximum
and minimum threshold.