Assembly Instructions
Universal
P
ri
n
te
d
in
U
.S
.A
.
©
2
0
1
0
K
im
b
a
ll
In
te
rn
a
ti
o
n
a
l,
In
c
.
T
8
0
0
.4
8
2
.1
8
1
8
F
8
1
2
.4
8
2
.8
3
0
0
Page 1 of 1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1741615 Revision D-10
Tackboards and/or
Powered Tackboards
Tools Required
■
Drill/Screw Gun
■
Level
■
#2 Phillips Head Bit
■
Small Blade Screwdriver
Hardware Required
■
#8 x
⁵⁄₈
" Flathead
Installation
1. Tackboards can be attached to any highback organizer to
provide a tackable surface. Tackboards can also be wall
mounted. The tack panel is provided with routed
channels on the back side to help manage cords. (Figure A).
2. Insert a screw into the hole of each loose Dual Lock™ pad,
4 or 6, as required. (Figure B).
3. Press pads with screw protruding against the pads which are
already mounted to the back of the tackboard, locking the
pads together. Position tackboard on mounting surface,
making sure it is level. Apply pressure on board over pads
to mark surface with screw points. (Figure C).
4. Carefully detach pads with small blade screwdriver and
fasten in locations previously marked in step 3. Position
tackboard against mounting surface, making sure it is level,
and engage until each pair of pads snap together.
5.
Wall Mount Caution:
Pads should be located on wall studs,
or secured to wall with anchors (not provided).
Figure A
Figure B
Figure C
Cable
Routes
Dual Lock
