Assembly Instructions
Transcend
™
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 1998782
Revision B-09
Page 1 of 1
Lateral File Drawer Removal
and Anti-Tip Mechanism
Tools Required
■
Phillips Screwdriver
Installation
1. Lateral files are equipped with an anti-tip mechanism. This
consists of a nylon or polyester cord strung in such a
manner that only one drawer can be fully opened at one
time. This applies to both 2 and 4 drawer lateral files.
2. To remove the drawers, unlock the unit and extend the
TOP DRAWER
fully forward. Remove the two (2) screws
from the inside of the drawer in the back. This will release
the square eyelet block attached to the back of the drawer.
Make sure rope does not exit eyelet. The drawer is now
ready to be removed (Figures A & B).
3. Press the quick-disconnect tabs on each side of the drawer
and pull forward and upward to remove the drawer from
the slide assemblies. (Figure C).
4. To reinstall the drawer follow Steps 2 and 3 in reverse order.
Test the file drawers to insure the anti-tip mechanism is
functioning properly. Not more than one drawer should
open completely at one time.
WARNING:
If the square eyelet block is not reinstalled
correctly, the anti-tip mechanism will not function as
designed and could result n injury if the unit would tip.
Figure A
Figure B
Figure C
Unscrew eyelet block
from back of drawer
(see Figure B)
Remove these
two (2) screws
P
ri
n
te
d
in
U
.S
.A
.
©
2
0
0
9
K
im
b
a
ll
In
te
rn
a
ti
o
n
a
l,
In
c
.
T
8
0
0
.4
8
2
.1
8
1
8
F
8
1
2
.4
8
2
.8
3
0
0
Rope
Second knot
to untie
Eyelet block
First knot
to untie
