This manual
is f
or
use b
y qualified personnel
onl
y
5.3.1. Firmware Updates
• Ensure that your HAB™ is connected to the INTERNET and added into HAB™ iT (the
HAB™ mobile application).
• Ensure your WiFi router and INTERNET connection are not using power from your inverter.
You do not want these devices to lose power during the update.
• If your HAB™ is using the scheduled charging feature, temporarily disable scheduled
charging.
• On the HAB™ iT Basic screen flip the slider-like switch highlighted in blue shown in Figure
20: KiloVault® HAB™ iT Basic Screen Slider Switch. The status should change to “No
charge or discharge.”
Figure 20: HAB™ iT Basic Screen Slider Switch
• KiloVault® HAB™ firmware updates take about 10 minutes.
• Firmware updates are usually timed to take place during the evening in North America.
• Depending on what part of the BMS is being updated, either the red “ALARM” LED will flash
by itself, or the red “ALARM” LED will flash along with the two bottom green LEDs in the
State of Charge bar.
• Firmware updates include BMS improvements to:
o
HAB™ to HAB™ Communications
o
Cycle Counting
o
State of Charge Calculation
o
Other BMS functions as needed.
• The WiFi adapter firmware cannot be updated.
Rev: 5.0
36
HAB Inst/UserManual REV5.0.indd 36
HAB Inst/UserManual REV5.0.indd 36
10/10/22 3:46 PM
10/10/22 3:46 PM
