4.6.1. Connecting the HAB™
Step
Description
1
Set the HAB™ address using the address DIP switch (refer to 4.6.7
Setting the HAB™ Address).
2
If you have multiple HAB™ units, daisy chain the RJ45 HAB to HAB CAN Bus cable be-
tween each unit. This leaves an empty Can-bus port on either end of the string to install
the provided RJ45 120 Ω Resistor Plug. (Refer to Section 4.6.3)
Note:
If a longer cable is needed,please contact KiloVault® Customer service.
3
Optional:
Connect the Mod-bus communication cable between the Leader HAB™ and
the inverter. Contact KiloVault® for a list of supported inverters.
4
Connect the power cables from the HAB™ to the inverter (or to the DC bus if installing
to multiple units), making sure to use over current protection as required. Torque the
battery cable terminals to 15Nm (11 ft-lb or 132 in-lbs)
Note:
Only 1/0 or 2/0 battery cables are permitted.
5
Close (switch to “On”) the Inverter main DC Breaker.
6
Close (switch to “On”) the battery breaker on the side of the HAB™
7
Press and hold the power button until the red “RUN” LED flashes. (Approx. 3 - 5 sec-
onds).
8
Wait five seconds for the HAB™ units pre-charge function to complete.
9
If installing more than one HAB™ simply repeat steps 7 & 8 until all the units have been
energized.
10
Activate inverter function on your inverter, if applicable.
This manual
is f
or
use b
y qualified personnel
onl
y
Rev: 5.0
2022
25
HAB Inst/UserManual REV5.0.indd 25
HAB Inst/UserManual REV5.0.indd 25
10/10/22 3:46 PM
10/10/22 3:46 PM
