3
5
5.1 Action Restriction
6. Description of Displayed Status Code
Code
Description
Release Locking Method
C1
One-time external GATE signal confirmation
External GATE Signal
Trigger One-time
C2
Two-time external GATE signal confirmation method
External GATE Signal
Trigger Two-time
C3
When “OKALL Stop” function is enabled, LCM screen will display
“C3” during OKALL.
Panel Enter Key/external
CONFIRM Key
C4
When “OKALL Stop” & “Gate Mode-Once” function are enabled;
LCM screen will display “C4” during OKALL.
External Sensor Switch
One-time + Panel
Enter/external CONFIRM
Key
C5
When “OKALL Stop” & “Gate Mode-Once” function are enabled;
LCM screen will display “C5” during OKALL.
External Sensor Switch
Two-time + Panel
Enter/external CONFIRM
Key
NST
NSQ
NSC
NST: Stop time after screwdriver start is less than LT/greater than
HT
NSQ: Stop torque after screwdriver start is less than LQ/greater than
HQ
NSC: Stop count thread after screwdriver start is less than
LC/greater than HC
Panel Enter Key/external
CONFIRM Key
OK
The LCM screen will display “OK” each time the fastening is in
position.
NA
OKALL The LCM screen will display “OK ALL” each time the fastening for
the entire batch is in position.
NA
NGT
NGQ
NGC
NGT: Stop time after screwdriver start is less than LT/greater than
HT
NGQ: Stop torque after screwdriver start is less than LQ/greater than
HQ
NGC: Stop count thread after screwdriver start is less than
LC/greater than HC
NA
Mode
Function Name
1
2
3
4
RunReverseTime
V
X
X
X
AutoReverseTime
X
V
X
X
PreTightentTime
X
X
V
X
Reconfirm Time
X
X
X
V
Note: V- can be set, X-OFF
Turn on the “NG Stop” function, when NG occurred in “RunReverse/AutoReverse/PreTightent” time,
the screwdriver can still be used without being locked.
