KidKraft Cedar Summit F29380, Инструкция по установке и эксплуатации, Страница: 89 / 120

89
Step 36: Attach TNR2 Slide Exit to Exit Elbow Assembly
A:
Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR3 Short Exit. (fig. 36.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1)
Pan Bolts (with TN1 lock nuts) starting with the bottom middle hole and working up each side. (fig. 36.2 and
36.3)
C:
At this point make sure all the slide bolts are tight.
Use a 7/16”(11mm) open end wrench to hold nut and
then tighten bolt with Quadrex Driver on Clamp Rings.
Hardware
5 x Pan Bolt
(LN1 lock nut)
PB1
Other Parts
Exit Elbow
Assembly
Bottom of Slide Views
TNR3
Short Exit PB1
Start with
this bolt
Slot of TNR3
Short Exit
PB1
PB1
1 x TNR3 Short Exit
Fig. 36.1
Fig. 36.2
Fig. 36.3
LN1
LN1