4
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Toggle
®
Tables - Triple Motor C-Leg Height-Adjustable Square Shoe Base, Model SS
Assembly Instructions
CAUTION:
If Channels (Wire Troughs) are used they are not to be used for routing
extension cords. Power supply cords are not to be routed across or through more
than one complete unit/worksurface.
Figure 4
leg-to-leg
spanners
(long)
control
box
M5.5 x 22
pan head
screw
square shoe
tabletop
M5.5 x 22
pan head
screw
M10 x 25
set screws
M5.5 x 22
pan head
screws
M5.5 x 22
pan head
screw
M5.5 x 22
pan head
screws
leg-to-leg
spanners
(short)
M10 x 25
set screw
M5.5 x 22
pan head
screw
base
end
base
end
Figure 5
control
box
M5.5 x 22
pan head
screw
square shoe
tabletop
1. Carefully turn tabletop upside down
on a soft, protective surface and
set the base assembly onto the
underside of the top. Position one
base end, so base mounting holes
align with tabletop mounting holes,
and secure base to top using six
M5.5 x 22 pan head screws. Slide
the other base end into position by
adjusting the cross-support tubes
to align base mounting holes to the
tabletop holes and secure with six
M5.5 x 22 pan head screws. Next,
secure the corner base mounting
holes to the tabletop mounting holes
using six M5.5 x 22 pan head screws
(Figure 4).
2. Insert and tighten sixteen
M10 x 25 set screws as illustrated,
through the cross support tubes and
down to the leg-to-leg spanners.
Torque to 4.5 ft/lb to secure
(Figure 4).
3. The control box can be mounted
in one of two locations, center
corner in front of the cross tube
assemblies (Figure 4) or between
the cross-tube assemblies on the
longer side of the table (Figure 5).
If desired, the control box can be
used as a template underneath the
tabletop to mark, then drill a hole
for an alternative mounting location.
Position the control box over the
pre-drilled mounting hole and secure
using two M.5 x 22 pan head screws
(Figures 4 & 5).
