
5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Board Deck Frame
Assembly Instructions
Board Deck Bed Frame Assembly
Note:
Board deck bed frame
installation is the same for single,
loft or bunk beds. Figures 3 & 4
illustrate single bed for simplicity.
Page 3 illustrates bunk bed
components to aid in assembly.
See page 6 instructions for Hang on
Megasurface Loft Bed assembly.
Caution:
Middle stringers for Board
Deck Frames are different than
middle stringers for Spring Deck
Frames. Assure that your middle
stringers match those of Figure 3.
Important:
End stringers (installed
at the head and foot of the bed) must
be oriented with the higher vertical
edge of the stringer to the outside
end of the bed, to capture the deck
boards at both ends of the bed.
1. Position end and middle stingers
over installed side rails as illustrated,
and insert the tongues of the
stringers into the “belt loops” in
the side rails. Tap stringers down to
secure the stringers in place
(Figure 3).
Note:
If a bed safety bar is to be
installed to bed assembly, refer now
to page 7 “Bed Safety Bar for Bed
Deck Frames”.
2. Bed decking consists of three boards
that are set in place between side
rails and are supported by middle
and end stringers. Set the outside
boards into place first, followed by
the center bed deck board (Figure 4).
Figure 3
tongue
side rail
belt loop
middle stringers
(deck board)
end stringer
(deck board)
end stringer
(deck board)
side rail
Figure 4
bed deck
board (outside)
bed deck
board (center)
middle stringers
(deck board)
end stringer
(deck board)