18
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Optional Accessories
Assembly Instructions
Center Drawer Assembly
1. Begin installation of the center drawer
by making sure the glides on each
side of the drawer are snapped in the
closed position. Find and remove the
hardware pack which is taped to the
inside of the drawer.
2. Position the drawer unit under the
worksurface at the desired location,
with the front edge of the drawer
being flush with the front edge of the
worksurface. Using a pencil, mark
the worksurface at the center slots of
the four mounting brackets
(Figure 13).
3. Drill four pilot holes not more than
1
/
2
” deep using a
1
/
16
” drill bit at
the locations marked for mounting
the drawer to the underside of the
worksurface (Figure 13).
4. Position the center drawer over the
pilot holes in the worksurface and
secure with four #8 x
1
/
2
” Phillips
screws (Figure 13).
Task Light
1. Carefully remove task light and
brackets from carton.
2. Assemble task light and brackets
by sliding brackets through the belt
loops at each end of the task light
(Figure 14).
3. Locate front of task light brackets
inside front lip of overhead shelf
bottom (Figure 15).
4. Flex rear of task light brackets
outward until brackets will pass over
rear lip of shelf bottom and slide in
place (Figure 16).
5. Route power cord out of sight to
a 115 volt grounded outlet. See
page 15 and Figure 8 for
Cord
Management
option.
center drawer
assembly
#8 x / "
Phillips screw
1
2
worksurface
front edge
drawer
glide
mounting
bracket
Figure 13
overhead
shelf
bottom
task light
front
bracket
Figure 15
Figure 16
task light
belt loop
task light
bracket
Figure 14