17
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Optional Accessories
Assembly Instructions
piano
hinge
#8 x 1"
screw
#10 x 1"
screw
#10 x 1"
screw
#8-32 x / ”
screw
3
8
anchor
bracket
hang-on
worksurface
drop-leaf
surface
drop-leaf
arm
Figure 12
Drop-Leaf Surface
1. Position both the drop-leaf surface
and the hang-on worksurface face
down on a soft protective surface.
The worksurface edges should be
touching and the front and rear edges
of both should be flush.
2. Center the piano hinge over the
seam where the worksurfaces meet.
Using the hinge as a template, mark
the holes onto both worksurfaces.
Remove the hinge and drill
1
/
8
” diameter pilot holes. Take
care not to drill too deep, piercing
through the surface. Keeping the two
worksurfaces together, attach the
piano hinge to both with twenty-four
#8 x 1” screws (Figure 12).
3. Position the anchor bracket on the
center of the hang-on worksurface,
2” back from the seam of the two
surfaces. Mark the nine holes
through the bracket and carefully drill
1
/
8
” diameter pilot holes. Attach the
bracket to the hang-on worksurface
with nine #10 x 1” screws
(Figure 12).
4. Secure the drop leaf arm to the
anchor bracket as illustrated with two
#8-32 x
3
/
8
” screws (Figure 12).
5. With the drop-leaf arm fully extended,
rotate it onto the drop-leaf surface.
Apply downward pressure to the arm
and mark the mounting holes on the
surface. Carefully drill
1
/
8
” diameter
pilot holes. Secure the arm to the
drop-leaf surface with two
#10 x 1” screws. When installing the
arm, make sure that enough support
is supplied by the arm to keep the
drop-leaf surface from sagging
(Figure 12).