19
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
RoomScape
®
Residence Hall Furniture - Optional Accessories
Assembly Instructions
buckle end
sling strap
slot D
" "
slot C
" "
slot A
" "
slot B
" "
handle
strap end
buckle clip
CPU holder
vinyl feet
strap bracket
#8 x /
"
screw
3
8
Figure 17
CPU Sling Assembly
1. Lay the CPU holder and strap bracket
out as illustrated in Figure 17. First
route the “end” of the sling strap
through slot “A” and slot “B” in the
strap bracket , and pull buckle end to
within a few inches of slot “A”. Next
route the strap end through slots “C”
and “D” in the CPU holder as shown.
Finally, following the arrow, route the
strap end through the buckle clip.
Follow the above procedure for the
other sling strap (Figure 17).
2. Secure the handle to the CPU holder
with two #8 x
3
/
8
” screws at the two
holes located above the vinyl feet
(Figure 17).
3. To mount the CPU to the CPU holder,
first set the CPU onto the straps and
strap bracket as shown. Position the
CPU holder onto the top of the CPU
with the vinyl feet resting against the
top of the CPU. The front vinyl feet
(at handle end) must set just behind
the font bezel on the CPU
(Figure 17).
4. Be sure the straps are wrapped
around the CPU as illustrated. Snap
the buckle together. Hold the CPU
securely and pull up forcefully on
the strap ends to tighten. The straps
must be pulled tight to secure,
and periodic re-tightening may be
required (Figure 17).
5. Determine the correct location
to mount the track under the
worksurface. The track must be
positioned square to the front edge
of the worksurface and set back from
the front edge to obtain a desirable
retraction position for your CPU.
Use the track as a template and mark
all eight of the hole locations on the
underside of the worksurface
(Figure 17).
