Ki Mobility Little Wave Clik XP, Инструкция пользователя и гарантия

Страница: 36 / 120

34
V. SET UP & USE OF YOUR WHEELCHAIR
R. Adjusting the Footrest
Height Adjustment of Footrest:
1. On each side of the frame loosen the 5mm screw
(Fig. 25:A).
2. Once the screw is loosened you may adjust the
footrest tube up or down to the desired height
within the side frame.
3. Try to ensure that both sides are adjusted equally.
4. Retighten the 5mm screw on each side.
Replacing Footrest for Width Adjustment:
NOTE: These instructions do not apply to High Mount footplates. Reference instruction in Section
KK - Clik - High Mount Flip Under Footrest.
1. Loosen the 5mm set screw on each side of the frame (Fig. 25:A).
2. Once the screw is loosened you may remove footrest assembly by sliding downward towards
the floor until upright tubes have been entirely removed from frame.
3. Take new footrest assembly and insert upright tubes into upright front frame tubes.
4. Set desired footrest height.
5. Retighten 5mm screw (Fig. 25:A).
S. Optional Angle Adjustable Footplate
To adjust the angle of the optional angle adjustable footplates:
1. Loosen, but do not remove, the two M6 screws (Fig. 26:A) securing the footplate to the
footplate clamp with a 4mm Allen wrench.
2. Once loose, the footplate will easily rotate around the footrest extension tube.
3. Select the desired position and retighten the two M6 screws to 80 in./lbs.
To change the position of the optional angle adjustable footplates:
1. Remove both M6 screws (Fig. 26:A) from the
footplate. There are M6 nylock nuts recessed on the
underside of the clamp. Be sure to prevent these
from falling as you loosen the screws.
2. Relocate the footplate and insert the screws into the
appropriate holes.
3. Fit the nuts into the slot underneath the clamp and
tighten the screws.
A
Fig. 25
A
Fig. 26