Ki Mobility Little Wave Clik XP, Инструкция пользователя и гарантия

Страница: 32 / 120

30
V. SET UP & USE OF YOUR WHEELCHAIR
N. Front Seat Height Adjustments (Continued)
2. Caster Housing Height Adjustment
NOTE: By changing the front seat height, the back angle and chair dump are affected. These
should be checked after making this adjustment.
The front seat height can be adjusted in ½" increments by moving the caster housing up or down
on front frame tube.
a. Loosen top two M6 bolts (Fig. 19:A).
b. Start with the left or right caster housing. Move caster housing up or down to achieve
desired front seat height. As you move you should feel the detent click into each dimple of
the frame.
c. Make sure each side is adjusted equally. This can be done by counting the clicks as you
move the caster housing and/or measuring each side after adjusted.
d. Once desired position is achieved retighten M6 bolts (Fig. 19:A).
e. Repeat on opposite side using the same number of clicks.
f. Resquare caster wheels as noted in Section P. - Caster Angle Adjustment.
WARNING: Changing the seat height may decrease stability of the chair. Always make
adjustments in small increments and check the stability of your chair with a spotter to prevent a
tip-over. We recommend that you use anti-tip tubes.
DANGER: Failure to heed these warnings may cause serious injury or death.
Fig. 19
A