Ki Mobility Little Wave Clik XP, Инструкция пользователя и гарантия

Страница: 55 / 120

53
V. SET UP & USE OF YOUR WHEELCHAIR
KK. Clik - High Mount Flip Under Footrest (Optional)
To adjust the angle of the footplates:
a. Loosen, but do not remove, the two 6mm flat head screws on center clamp.
b. Once loose, the clamp will rotate around the footrest extension tube.
c. Select desired position and retighten the two 6mm flat head screws to 80 in./lbs.
To change the position of the optional angle adjustable footplates:
a. Remove both M6 screws (Fig. 50:A) from the footplate. There are M6 nylock nuts recessed
on the underside of the clamp. Be sure to prevent these from falling as you loosen the
screws.
b. Relocate the footplate and insert the screws into the appropriate holes.
c. Fit the nuts into the slot underneath the clamp and tighten the screws.
To change the height of the footplate on frame:
a. Slightly loosen both 6mm screws (Fig. 50:B) from the footplate clamp. Keep the clamp snug
so that the assembly holds together. Repeat on other side of the wheelchair.
b. The entire footplate assembly will slide up and down on the frame.
c. After locating desired position, tighten one 6mm screw (Fig. 50:B) slightly on each side.
Once secure finish tightening the four 6mm screws (Fig. 50:B). Turn each screw a little at a
time to prevent the clamp from clamping down unevenly.
NOTE: Tightening the screws unevenly may result in damage to the threads inside the clamp.
Fig. 50
A
B