Step 4: Install the Modules
5. Holding the module by the injector/ejector handle, slide it into a compatible slot, as shown in the figure
below.
a. Install the module into the PXI slot of the chassis by placing the module card edges into the front
module guides (top and bottom).
b. Assure that the injector/ejector handle is pushed down in the unlatched (downward) position. Slide
the module to the rear of the chassis
c. Slide the module completely into the chassis. When you begin to feel resistance, pull up on the injec-
tor/ejector handle to fully insert and latch the module into the chassis.
6. Secure the front panel to the chassis using the two module front-panel mounting screws. Performance may
suffer if the screws are not tightened properly.
7. Verify that the PXI chassis fans are operable and free of dust and other contaminants that may restrict air-
flow.
8. Install all filler panels after installing the modules. Missing filler panels may disrupt necessary air cir-
culation in the chassis.
9. If you are using a PC host, such as the Agilent M9021, connect the Cable Interface in the chassis to the
PC host per the instructions that came with the Cable Interface.
10. Power up the PXI chassis.
11. Reboot the PC host.
12. Run the module soft front panel (SFP) software, this initializes the module.
13. Check the status LEDs on the module front panels.
14
Agilent M9392A PXI Vector Signal Analyzer Startup Guide
Содержание M9392A
