Kersten KM 13050 H-ABR 50, Руководство по эксплуатации

Страница: 15 / 20

Maintenance
15
8 Operation
8.1 Operating instructions - Sweeper
Adjust the two support wheels with the help of the turning handles in such a way that the roller
brushes a about 4 cm wide strip on the ground depressed. It is important to pay attention to the
same setting of the two support wheels according to the marking on the scale graduation!
Note: A sweeping roller set too tight will not produce better sweeping results.
Attention: Never store the sweeper on the broom.
For easier storage and installation of the sweeper we recommend the additional two support
wheels, which are available as special accessories.
8.2 Dirt collecting setting
Install the sweeper with container on the carrier vehicle and adjust the top link so that
the trailing edge of the container is approx. 4 cm and the leading edge
have about 7 cm ground clearance.
Depending on the degree of wear of the sweeping roller, the collecting container must be placed in
the corresponding holes so that the setting dimensions: 4 cm and 7 cm are maintained. Here, the
container may be better higher than too deep.
Attention: Please adjust carefully for very uneven ground conditions!
8.3 Side brush - setting
Please adjust the side broom only when the main broom and the dirt collector are set.
The height is adjusted by operating the spindle on the mounting plate.
The best sweeping performance with a side brush results in a sweeper that is slightly tilted
towards the middle of the road.
When not in use, fold up the side broom and secure it, this is also the storage position.
When dismantling the side broom and operating the sweeper without a side brush, it is essential
that the hydraulic hoses are put into circulation.
Make sure that the hydraulic connectors are clean!
For storage of the sweeper be sure to relieve the sweeping roller!