Kersten KM 13050 H-ABR 50, Руководство по эксплуатации

Страница: 12 / 20

Service
12
Turning handle for
height adjustment g.
Support wheel roller
Spindle for height
adjustment Surface-
mounted side brush
Joint-wave
S
ide broom
Stabilizer
Bearing Shell
tension rod
Container stop
7.3 Cultivation of a KM 13050-22550 H-ABR 50
Insert the two hydraulic lines (supply and return) for the sweeper drive into the hydraulic sockets on the
tractor.
Depending on the version, the machines are equipped with a hydraulic swiveling device. Insert the
hydraulic hoses into the hydraulic sockets provided on the tractor.
Pay attention to the cleanliness of the plug-in couplings.
7.4 Mounting dirt collector
Screw the two stops for the collection container left and right on the sweeper. Secure the supplied
rubber cloth on the upper front edge of the sweeper by means of a sheet metal rail. To do so, place
the sheet metal rail flush and screw together with M6 x 20 mm screws, 2 washers each and stop nut.
Hook the dirt collector into the holes provided on both sides with the help of the locking pins and
secure with clippings.
Hook in the hydraulic cylinder for the hydraulic tank emptying and with a Secure the folding pin. Route
the hydraulic hose towards the tractor. The length of the hose and the type of plug-in coupling to the
tractor depend on the type of tractor - please specify this when ordering!
7.5 Mounting side brush
Attention: Each delivered KM with side brushes is delivered without oil for transport reasons.
Make sure to top up with oil before using the KM otherwise oil pump damage will occur!
Please use hydraulic fluid with a viscosity of 46, which is biodegradable or an equivalent oil.
For mounting the hydraulic pump
First, install the two fixing screws of the gearbox (in the direction of travel, right), coupling of the side
broom on the gearbox side with thrust ring and Seegering.
Insert the feather key into the groove and attach the pre-assembled coupling to the gearbox
and secure with the washer and the screw.
Now the coupling pinion can be mounted on the pump side with the stop ring and the
Seegering.
Attach the pump with pump holder to the coupling and fasten the pump holder to the gearbox
holder with the two screws.