KEPCO KLN 100-7.5, Руководство оператора

Страница: 52 / 86

3-16
KLN 750W 121912
3.3.30 VIEW FIRMWARE VERSION
Allows viewing of firmware version
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (FW). to view the unit firmware version.
2. Firmware Version displayed as 1.00 (typical) in Current display.
3.3.31 VIEW HARDWARE VERSION
Allows viewing of hardware version
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (HW). to view the unit hardware version.
2. Hardware Version displayed as 1.00 (typical) in Current display.
3.3.32 VIEW 1ST PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to view first part (nnn) of the 4-part IP address (nnn.xxx.xxx.xxx) where nnn is a number
from 0 to 254. The IP address shown is either assigned by the DHCP server or the static
address entered manually. The default IP address is 192.168.0.100.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.IP1).
2. Press ENTER key to view setting.
For example, (192) displayed in Current display for IP Address 192.168.0.100.
3. To change the IP address from the front panel, first set DHCP function to OFF (see PAR.
3.3.19) then refer to PAR. 3.3.20 through PAR. 3.3.23 to change the address. Cycle power
off, then on before returning to PAR. 3.3.32 through 3.3.35 to view the changes. The IP
address can also be changed using SCPI commands (see Appendix B, PAR. B.37).
3.3.33 VIEW 2ND PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to view second part (nnn) of the 4-part IP address (xxx.nnn.xxx.xxx) where nnn is a num-
ber from 0 to 254. The IP address shown is either assigned by the DHCP server or the static
address entered manually. The default IP address is 192.168.0.100.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.IP2).
2. Press ENTER key to view setting.
For example, (168) displayed in Current display for IP Address 192.168.0.100.
3. To change the IP address from the front panel, first set DHCP function to OFF (see PAR.
3.3.19) then refer to PAR. 3.3.20 through PAR. 3.3.23 to change the address. Cycle power
off, then on before returning to PAR. 3.3.32 through 3.3.35 to view the changes. The IP
address can also be changed using SCPI commands (see Appendix B, PAR. B.37).