KEPCO KLN 100-7.5, Руководство оператора

Страница: 73 / 86

KLN 750W 121912
A-1
APPENDIX A - SCPI COMMON COMMAND/QUERY DEFINITIONS
A.1 INTRODUCTION
This appendix defines the SCPI common commands and queries used with the KLN 750W power
supply. Common commands and queries are preceded by an asterisk (*) and are defined and
explained in paragraphs A.2 through A.7, arranged in alphabetical order. Table A-1 provides a quick
reference of all SCPI common commands and queries used in the Interface Card.
A.2 *CLS — CLEAR STATUS COMMAND
*CLS
Syntax: *CLS
Description: Clears status data. Clears the following registers without affecting the corresponding Enable Regis-
ters: Standard Event Status Register (ESR), Operation Status Event Register, Questionable Status
Event Register, and Status Byte Register (STB). Also clears the Error Queue.
A.3 *IDN? — IDENTIFICATION QUERY
*IDN?
Syntax : *IDN?
Return value: Character string
Description: Identifies the instrument. This query requests identification. The power supply returns a string
which contains the manufacturer name, the model, the serial number and the firmware level. The
character string contains the following fields: <Manufacturer>, <Model>, <Serial Number>, <Firmware
revision> where: <Manufacturer> = KEPCO, <Model> = KLN 750W model number, <Serial Number>
= SSSSSS <Firmware revision=n.m, (e.g, 1.0).
A.4 *OPC — OPERATION COMPLETE COMMAND
*OPC
Syntax : *OPC
Description: Causes power supply to set status bit 0 (Operation Complete) to “0” indicating the unit is busy.
When pending operations are complete
this status bit is set to “1.” This command sets Standard
Event Status Register bit 0 to “0.” Subsequent *OPC? commands return “0” until all previous com-
mands have been executed and changes in output level have been completed. When all microproces-
sors are idle, *OPC? return “1.”
*OPC? must be proceeded by *OPC to first clear status bit 0, otherwise the *OPC? will return a “1”
that has no meaning. This command does not prevent processing of subsequent commands, but bit 0
will not be set until all pending operations are completed. (1 = set = enable function, 0 = reset = dis-
able function). As an example, the controller sends command(s), then sends *OPC. If controller then
sends *ESR?, the power supply responds with either a “0” (if the power supply is busy executing the
programmed commands), or a “1” (if the previously programmed commands are complete).
TABLE A-1. IEEE 488.2 COMMAND/QUERY INDEX
COMMAND PAR. COMMAND PAR.
*CLS A.2 *RST A.6
*IDN? A.3 *TST? A.7
*OPC, ? A.4, A.5