KEPCO KLN 100-7.5, Руководство оператора

Страница: 53 / 86

KLN 750W 121912
3-17
3.3.34 VIEW 3RD PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to view third part (nnn) of the 4-part IP address (xxx.xxx.nnn.xxx) where nnn is a number
from 0 to 254. The IP address shown is either assigned by the DHCP server or the static
address entered manually. The default IP address is 192.168.0.100.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.IP3).
2. Press ENTER key to view setting.
For example, (0) displayed in Current display for IP Address 192.168.0.100.
3. To change the IP address from the front panel, first set DHCP function to OFF (see PAR.
3.3.19) then refer to PAR. 3.3.20 through PAR. 3.3.23 to change the address. Cycle power
off, then on before returning to PAR. 3.3.32 through 3.3.35 to view the changes. The IP
address can also be changed using SCPI commands (see Appendix B, PAR. B.37).
3.3.35 VIEW 4TH PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to view fourth part (nnn) of the 4-part IP address (xxx.xxx.xxx.nnn) where nnn is a number
from 0 to 254. The IP address shown is either assigned by the DHCP server or the static
address entered manually. The default IP address is 192.168.0.100.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.IP4).
2. Press ENTER key to view setting.
For example, (100) displayed in Current display for IP Address 192.168.0.100.
3. To change the IP address from the front panel, first set DHCP function to OFF (see PAR.
3.3.19) then refer to PAR. 3.3.20 through PAR. 3.3.23 to change the address. Cycle power
off, then on before returning to PAR. 3.3.32 through 3.3.35 to view the changes. The IP
address can also be changed using SCPI commands (see Appendix B, PAR. B.37).
3.3.36 VIEW 1ST PART OF SUBNET MASK ADDRESS (LAN INTERFACE ONLY)
Used to view first part (nnn) of the 4-part Subnet Mask address (nnn.xxx.xxx.xxx) where nnn is
a number from 0 to 255. The default subnet mask address is 255.255.255.0.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (V.MN1).
2. Press ENTER key to view setting.
For example, (255) displayed in Current display for subnet mask address
255.255.255.100.