Kenwood XD-981MD, Инструкция по эксплуатации

Страница: 26 / 84

XD-981MD (En)
26
Preparation section
Basic section
Application section
Knowledge sections
Let's put out some sound
Searching for the desired music program
(DPSS)
The DPSS (Direct program Search System) is capable of detecting non-recorded spaces of more than 4 seconds as “blanks
between programs ”and, based on this information, can return to the beginning of the music program being played or the
beginning of a desired program by skipping up to 16 other programs.
During play in direction
3
To play the next program : Press once.
To play the 4th program
after the current program
: Press 4 times.
To return to the beginning
of the current program
: Press once.
To play the 4th program
before the current program : Press 5 times.
During play in direction
2
To play the next program : Press once.
To play the 4th program
after the current program
: Press 4 times.
To return to the beginning
of the current program
: Press once.
To play the 4th program
before the current program : Press 5 times.
The DPSS may not function normally with the following kinds of tape.
÷
Tapes containing several no-sound intervals of more than 4 seconds, such as conversation and talk tapes.
÷
Tapes containing pianissimo sections, such as classical music tape.
÷
Tapes in which large noise is recorded in blanks between programs.
÷
Tapes containing blanks between programs that are shorter than 4 seconds.
÷
Tapes recorded at low level.
÷
Tapes recorded by cross-fade recording (in which the beginning of next program is overlapped on the end of previous program).
Notes Notes
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is loaded.
By writing down the counter reading in case you want to inter-
rupt recording (playback) in the middle of the tape, the memo
will be helpful as a reference for locating the same position when
continuing the recording (playback) the next time. The tape
counter figure decrements during recording or playback of the
back side (while the
2
tape transport indicator is lit).
To set the tape counter to “0000”, open the cassette holder once.
Then the counter will be reset.
DIGITAL
MD CD
8 0 0
:
00
.
** *
VOL
T A P E D S T O P 1
0
3
0
2
0
1