
TK-5310
15
3. Remove the separation paper (white) from the sheet in
step 1
v
, then attach the LCD ASSY
b
to the sheet.
4. Attach two pieces of double-sided adhesive tape
n
to the
back of the holder and remove the separation paper.
5. Remove the protection sheet (transparent) attached to
one side of the new filter
m
,
and remove the protection
sheet (yellow) from the other side
.
.
6. Attach the filter from step 5 to the back of the holder.
7. Attach the new cushion
/
so that it fits to the corner of
the holder convex.
■
Preparation when Replacing the Cord ASSY
(X42-3270-10)
Cut the tip of the FPC on the side on which "TX-RX" is
stamped when replacing the cord ASSY.
■
Procedures when Replacing the Top Panel
1. Insert the O-ring
z
into the lever switch part of the new
top panel.
2. Apply grease to the base of the shaft of the lever knob
x
and install the lever knob so that it is in the "
-
" position
(circle painted in white) on the top panel
c
.
3. Pass the hardware fixture
v
through the shaft and install
it onto the top panel.
4. Apply grease to between the two holes in the hardware
fixture
v
.
5. Install the hardware fixture
b
so that it is inserted into the
hole on the left side of the hardware fixture
v
.
z
z
x
c
c
v
n
m
n
n
,
.
n
b
b
/
/
CUT
TX-RX
CONT
Cord Assy(X42-3270-10)
6. Fix the two hardware fixtures with the hexagon nut
n
.
7. Apply bond (Three Bond 1401C) to the tip of the lever
knob shaft and the surface of the hexagon nut
m
.
■
Volume Knob and Channel Knob Parts Replace-
ment
Since the volume knob consists of two components, a
knob
z
and a spacer
x
, replace and reinstall these two
parts at the same time.
Since the channel knob consists of three components, a
knob
c
, a 16CH display seal
v
and a spacer
b
, replace
and reinstall these three parts at the same time.
■
Procedure when replacing the universal connector
FPC (J82-0097-25)
When assembling a new universal connector FPC, insert
the FPC into the chassis hole by gently bending the FPC
as shown in the figure.
Apply grease to between
the two holes in
the hardware fixture.
Apply bond (Three Bond 1401C)
to the tip of the lever knob shaft
and the surface of the hexagon
nut.
Top panel
Inserted into the hole
on the left side of the
hardware fixture.
Apply grease to the
base of the shaft of
the lever knob.
z
v
m
b
n
x
c
Volume Knob
Channel Knob
z
c
b
v
x
DISASSEMBLY FOR REPAIR
Universal
Connector
Do not bend the FPC at a sharp angle.
Universal connector FPC
Wrong
Universal
Connector
Bend the FPC gently.
Universal connector FPC
Universal connector FPC
(J82-0097-25)
Right
Содержание TK-5310
Страница 96: ...TK 5310 91 MEMO ...