27
• The marked CH numbers are the default channel settings.
SCAN
Scan is useful for monitoring signals on the transceiver
channels. When scanning, the transceiver checks for a signal
on each channel and only stops if a signal is present.
If the QT/DQT matches, the transceiver stops at the channel
and opens the squelch so you can listen to the call. If the
QT/DQT does not match, the call is ignored and scanning
continues.
Before you can use the scan function, ensure that it is
activated. You can turn the scan function (the ability to perform
scan) ON or OFF in Setting Mode.
1
Enter the Setting Mode {page 24}.
2
Press the
or
key to select “ ”.
3
Press the
MENU
key then press
or
to
select “
” (scan function disabled) or
“
” (scan function enabled).
• If you select “
”, you will no longer be able to perform scan
by pressing and holding the
key.
To begin scanning:
1
Press and hold the
key for 1 second.
• “
” appears on the display.
2
When a signal is detected and the QT/ DQT matches, the
channel number appears on the display and blinks.
3
When the signal is no longer present, the transceiver waits
for 5 seconds before scanning continues.
• If a new signal appears before the 5 seconds elapse, the
transceiver will remain on the channel until the new signal is
no longer present, at which time it will again wait for 5 seconds
before continuing.
