NX-200
7
INSTALLATION
3. Remove the OPTION PCB from the connector (CN710)
of the Control PCB.
CN710
OPTION PCB
4. Attach the flat spring (G02-1846-03) to the VGS-1 as
shown in the fi gure.
Note:
Attach the fl at spring so that its convex fi ts the PCB hol-
low of the VGS-1.
5. Attach the cushion (G13-1974-04) to the VGS-1 as shown
in the fi gure.
Note:
Be sure not to cover the VGS-1 connector with the cush-
ion.
6. Insert the VGS-1 connector into the connector (CN710)
of the Control PCB.
CN710
VGS-1
VGS-1
Flat spring
(G02-1846-03)
Convex part
PCB hollow
VGS-1
Flat spring
Cushion
(G13-1974-04)
21x21x1.0mm
Cushion
7. Reinstall the cover using the two screws removed in
step 1.
DISASSEMBLY FOR REPAIR
1. Precautions for Waterproof
• Do not remove the black sheet from the reverse side of
the transceiver (refer to the illustration right). Removal
of this sheet decreases the waterproof effi ciency of the
transceiver and may cause malfunctions if water seeps
into the transceiver.
• The orange packing material on the reverse side of the
transceiver is important with respect to the waterproof
efficiency of the transceiver. Do not place stickers or
other materials on or around the packing material shown
in the fi gure, or on the reverse side of the battery pack.
Doing so will impair the waterproof efficiency of the
transceiver and may cause it to break down. Additionally,
in order to prevent damage to the packing material, do
not allow it to come in contact with foreign materials.
