35
R
emote Setup
Chapter Two : Setting Up the Remote Control Unit
Selecting the input:
Audio device:
Press the
MUSIC
key repeatedly. The input
names where audio devices are identified
by Remote Control unit will be shown on
the LCD screen.
1
CD1 :
2
MD/Tape1 :
3
Tuner :
4
CD-R :
5
Phono :
If an audio device which is connected to an
input is not identified by Remote Control
unit, the device name is skipped and not dis-
played.
Video device: Press the
MOVIE
key repeatedly. The input
names where video devices are identified by
Remote Control unit will be shown on the
LCD screen.
1
Video1 :
2
Video2 :
3
Video3 :
4
Video4 :
5
DVD/6ch :
6
AV AUX :
Remote Control unit is a new type of remote control unit
which receives information from the receiver and display it
on the LCD screen.
This section describes the basic operations of Remote Con-
trol unit.
Turning power on:
To turn the receiver on: Press the
SYS.POWER
key.
To turn the connected device on: Press the
AV. POWER
key.
(It is necessary to perform the procedure in “Identifying
Components for Remote Control Unit” to enable remote
control of AV devices.)
Adjusting the receiver’s volume:
Press the
VOL
(+/-) key repeatedly until the desired volume
is obtained.
Muting audio temporarily:
Press the
MUTE
key.
To resume the original volume, press the
MUTE key again or press one of the VOL
(+/-) keys.
Using the numeric keys:
When entering a figure directly for selecting a CD track num-
ber, etc., press the numeric keys as shown below.
To enter 5
:
To enter 25
:
or
:
2
+
-
VOL.
VOL.
Screen menu control operation
2WAY LCD REMOTE CONTROL UNIT
REC
REC
The contents of the func-
tion keys vary according to
current situations, and the
function names (Next,
Back, Enter, etc.) are shown
on the screen.
For details, see the descrip-
tion of each control opera-
tion.
Press to select an item by
scrolling the screen menu
up or down.
The selected item is dis-
played in an inverted color.
Basic Operation of Remote Control Unit
If a video device which is connected to an in-
put is not identified by Remote Control unit,
the device name is skipped and not displayed.
(VR-4080/KF-V7773D only)
Although
VIDEO4
is displayed in the initial
status, the receiver cannot be switched to se-
lect
VIDEO4
. The
VIDEO4
display will not
appear after the Remote Control unit has been
set up.
TV: Press the
TV
key. The LCD screen shows TV if this is
registered in and identified by Remote Control unit.
01.IR
02.Surround
03.Contrast
Home Enter
LCD
Function
key 1
LCD
Function
key 2
