Kenmore 796.4107 31 Series, Руководство по обслуживанию

Страница: 19 / 59

20
No. n o it a n a l p x E s s e c o r P
10 Intermittent
spin • To reach the correct set speed, the motor rotates clockwise and
counterclockwise directions after spin process starts.
• If the water level frequency is lower than 23.0 kHz,
a washer senses suds and starts suds removal process.
11 Rinse
spin • In this process, the remaining water during washing process is
extracted and the selected speed is kept.
• Removing suds process is in active mode at this cycle.
12 Remaining
spin • After spin finishes, the drum rotates by remaining spin power until it
stops. Motor power is off.
• This process is overlapped with next process.
13 Rinse water
supply • Water supply for rinse process.
14 Rinse • Rinsing process.
15 Last
drainage • After spin finishes and power is not supplied to motor, the drum
rotates by remaining spin power.
• If rinse hold is selected, the drainage is not proceeded after rinse
finishes.
16 Disentangling • The same as item 9.
17 Intermittent spin
• The same as item A.
18
19
20
21
22
Main spin1 • The same as item B.
Main spin2 • At the end of a main spin, the spin speed will reach the selected rpm.
Remaining spin • The same with item C.
Disentangling • After spin finishes, disentangling starts to remove unbalanced
laundry.
End • After ‘end’ signal is displayed, it stays for 8 seconds and power is
automatically turned off. (Auto type door switch)
• After door switch is off, end signal is displayed in the case of
manual type and it takes around 2 minute to turn off door switch.