Kemper Champion C 1200, Руководство по эксплуатации

Страница: 46 / 59

35 Greasing chart C 1200
Servicing intervals The indicated servicing intervals are calculated for normal operating
conditions. Before lubricating clean the grease nipples. Damaged grease
nipples have to be replaced. If a new grease nipple should not accept
grease, remove it and find the cause of blockage.
Caution!
Cleaning, lubricating and adjusting work may only be carried out with the
engine stopped. Wait for all machine components to be at a complete stop.
All lubricating and maintenance jobs have to be carried out before and after
every season.
Symbols
= Grease every 50 working hours A = Oil drain plug
= Grease every 100 working hours E = Oil filler plug
= Grease every day L = Breather
= 1,5 liter transmission oil SAE 90 N = Grease nipple
= Periodically grease all hinge points P = Oil level check plug
= Grease, semi fluid Aviaticum XRF
Greasing chart 1 = Feed roller – lower bearing
2 = Feed roller – lower bearing
3 = Precompression roller – lower bearing
4 = Pivot – top bearing
5 = Pivot – lower bearing
6 = Free wheel mechanism
7 = Intake drum – lower bearing
8 = Intake drum – top bearing
9 = Flywheel cutting disc – front bearing (grease nipple on gearbox)
10 = Flywheel cutting disc – rear bearing
11 = Grinding stone bearing
12 = Pivot discharge chute
13 = Main PTO
14 = Flywheel cutter – hub – shaft
15 = Flywheel cutter – hub – shaft
16 = PTO shaft between the gearboxes
17 = Optional equipment – crop divider 2 nipples
18 = Optional equipment – support wheel
19 = Swivel point chute
21 = Angle drive – flywheel cutting disc: 0.3 = Semi fluid grease XRF
22 = Spur gear – precompression roller: 1.0 = Semi fluid grease XRF
23 = Angle drive – main drive:
1.3 = SAE 90 Oil
24 = Angle drive – pivot: 0.5 = SAE 90 Oil
25 = Pendulum drive: 0.5 = Semi fluid grease XRF